Pearce Grips Plus Two Magazine Extension, model PG-BHP9. For use on the following high-capacity magazines: Beretta 92, Browning High Power, and SigArms P228/P229. Black.

This magazine extension replaces the magazine floor plate adding two rounds capacity to factory pre-ban high capacity magazines. It is supplied with a replacement locking sub-floorplate to insure a secure installation

Features:

These units alter the capaci [...]

Pearce Grip Mag Extension - Fits Ber92, Brng HP, & Sig P228/P229, Black

By gg
Review Date: 11/14/2008
Rating: Pearce Grip Mag Extension - Fits Ber92, Brng HP, & Sig P228/P229, Black

Purchased From This Site: Yes

These fit on CZ pistol magazines just fine. Omit the inner spring cage, and trim the follower as needed in order to reliably feed in and out of the extension. I was able to make 15+1 in 40sw and others have reported as many as 23+1 in sp-01 magazines for 9mm. Your mileage may vary. I have not figured a way to retain the base to the magazine tube to keep it from sliding foward - however, when a magazine is fully loaded, the extension isn''t going anywhere. I shoot these extensions as 15+1 with a CZ-40b in USPSA Limited Division.

1 of 1 found this review helpful

Yes

Was This Review Helpful?

Bookmark This Page:

LasermaxWorld.com lasermaxforless.com lasermaxlasers.com meprolightstore.com meprolightoutlet.com meprolightgunsights.com

Privacy Statement Legal Statement Return Policy Affiliate Program